- Country of manufactureUkraine
- Diameter4.0, 5.0 mm
Welding electrodes of TML-5
Electrodes for welding alloyed heatproof by staly TML-5
|E06H1M type *|
For tea leaves of defects in cast details of the power equipment from staly 20HML, 20HMFL, 15H1M1FL and to them similar without the subsequent heat treatment. Welding in all spatial provisions, except vertical from top to down, a direct current of the return polarity.
|Current, And||Constant, return polarity|
|Provision of welding||Diameter of an electrode, mm|
|Vertical (from below up)||60-90||100-130|
|The provision of the welded seams|
|Chemical composition of metal of a seam (typical value), %|
|Mechanical properties of metal of a seam (typical value)|
|Temperature of tests, ºС||Temporary resistance to a gap,
|Relative lengthening, %||Impact strength,
MDzh/sq.m (kgf of m/cm2)
|+ 20||539 (54,0)||22,0||1,3 (13,0) (type VI)|
|—||—||1,0 (10,0) (type IX)|
|Humidity of electrodes before application ≤ 0,5%|
|Recommendations - Electrodes provide high resistance of metal of a seam to formation of a time when lengthening an arch, allow to carry out welding in narrow cutting. To carry out welding a short arch, to smooth out edges before welding.
Repeated calcination of electrodes before welding 380÷420 ºС during 1,0÷1,5 hour.