- Country of manufactureRussia
|Suture and repair universal material Element - Non - shrinking waterproofing one - component composition, which is a dry building mixture of gray color with reinforcing fillers. The composition of the material includes Portland cement, quartz filler, reinforcing elements and active chemical additives, with a high content of fiber.
The material is distinguished by excellent plasticity, high strength, no shrinkage, and has high adhesion to concrete, brick and stone. Differs in ease of use of the ready - made solution in comparison with other materials * . It can be used as an improving and reinforcing additive in concrete when pouring screeds, blind areas, steps, etc.
Water resistant W16
Resistant to hydrostatic pressure
High degree of adhesion to concrete, brick, stone, reinforcement
Forms a durable layer resistant to mechanical damage
Suitable for both indoor and outdoor use
Frost resistance f300 (minimum)
Waterproofing of mines, collector structures and tunnels, residential and non - residential facilities, during the construction of pools and reservoirs
Seams of vertical and horizontal surfaces
Bathrooms and toilets
In basements and basements
High quality Portland cement
Chemical additives providing plasticity, frost resistance, sulfate resistance and resistance to aggressive environments
Mixes are prepared for use by mixing with water to a "plasticine consistency". The material is laid in seams and pre - prepared grooves after preliminary treatment of the latter with penetrating waterproofing "Element".
STAGES OF WATERPROOFING DEVICE AND SEAM REPAIR
Extend the strobe with a perforator up to 2 - 3 cm
Clean joints and seams from loose material and unstable inclusions
Clean the surface of seams and concrete from small particles and dust with a high pressure washer, saturate the surface with water
Apply a layer of penetrating waterproofing with a brush - maklavitsa to strengthen the base, heal microcracks and the main waterproofing
Mixing the solution:
Water is added to the container with the dry mixture and diluted by continuous stirring with a construction mixer
· It is recommended to plug the mixture with water in small portions in order to avoid "false setting" of the material, since the repeated addition of water is not permissible.
· With hands protected with rubber gloves, or using a spatula, lay the finished suture repair material "Element" on the pre - treated seam with penetrating waterproofing "Element", sealing it, leaving no air pockets inside the seam.
· Apply a layer of penetrating waterproofing "Element" on the seam and on the concrete body in two layers with a brush - a spatula, or a spatula
After completing the above work, the surface must be protected from drafts, sun and high temperatures
After 6 - 8 hours, the surface must be moistened three times at intervals of 2 - 3 hours.
* series "Element"