Vapor-permeable membrane Izospan And, 70 m ²
- 18.95 EUR/roll - from 2 roll
- Customer pickup,
- Courier
- In detail
- BrandИзоспан
- Country of manufactureRussia
- Фасовка70 м²
Izospan And – vetro-and moisture insulating vapor-permeable type of membranes. Functions of this type of Izospan come down to protection of internal parts of designs, walls, roofs against negative weather conditions, and also promotes aeration of drop moisture. On the one hand, membrane smooth waterproof, and the second party rough.
Distinctive characteristics of Izospan And:
- easy and bystry assembling;
- the increased durability;
- high rate of vapor permeability;
- resistance to UV rays;
- small weight and sizes.
Scopes of Izospan And:
- in installation of system of the warmed cattle roof;
- in installation of system of the ventilated facade;
- at the device of walls with a framework and walls with external warming.
Technical indicators are presented in the table.
|
Density, g/m2 |
Structure |
The maximum force of stretching in prod./poperechn. direction, mm H/50, not less |
Density of a stream of water vapor, / м2*24 h, not less |
Water resistance mm.vod.st., not less |
UF-stability, month. |
|
110 |
100% polypropylene |
190/140 |
2000 |
300 |
3-4 |
Roll sizes:
- width, m – 1,6;
- the size, sq.m – 35, 70.
Recommendations:
- Mounting system of the warmed cattle roof Izospan And have directly over support (rafters) over a heater so that a smooth part was above, then by means of self-tapping screws and counterlaths fix to rafters. It is important to make a gap between a heater and a membrane of 40-50 mm. Begin to stack material from a roof bottom, by an overlap. After Izospan And establish an obreshetka and a roof. Between a membrane and a roof it is also required to leave a gap.
- At installation of systems of the ventilated facades, frame and walls with external warming a membrane have in a design over a heater a smooth side outside that there were no gaps. Further carry out further finishing. It is important to leave a gap between a membrane and the subsequent finishing of 4-5 cm in size.