- Country of manufactureChina
- MaterialStainless steel
- Process automationAutomatic
Two bladed desktop vacuum packer of DZ-400-2D are the typical representative of the inexpensive but reliable equipment. It is necessary to refer to advantages of this car first of all simplicity and reasonableness of a design. Having weakened two screws in the lower part of the packer, by the way there are enough large, it is possible to cast away facing and to get access to all knots. As well as hatches for oil replacement are provided in the previous model in this packer.
Console management is executed on usual timers that allows to make repair in case of need in any conditions and will not cause difficulties in acquisition of spare parts. It is necessary to refer to shortcomings of simplicity only lack of the high-quality micro elevator of a vacuum cover. But it does not affect reliability at all. As practice Vacuum packers of DZ-400-2D regularly shows and without problemno work for years. At the correct operation only in 5-6 years replacement of laying on the vacuum pump is required.
Quality of a zapayka at very good level. Eight millimetric corrugated seam reliably hold vacuum.
Due to original hinged fastening of a vacuum cover it is considerably increased service life of vacuum consolidation is increased and its insignificant damage is allowed.
Packer vacuum DZM-400-2D
The vacuum packer of DZ-400-2D is intended for packing of products without air. The floor vacuum device is widely used to vacuum packing of foodstuff. This model has the increased productivity at the expense of two welding levels in the volume camera. An opportunity to carry out visual control through a transparent cover is given. The device is convenient in leaving and operation as its case is manufactured of stainless steel which also increases equipment service life. After packing products are reliably protected from oxidation, a mold, insects, dampness, and remain fresh for long term. The device is completed with all necessary spare parts and special vacuum oil.
Maximum pressure of vacuum ― 1,0 KPA. Length and width of a welded seam ― 400*10mm. Productivity of the vacuum pump ― 20 m3/hour camera Sizes (d\sh\v) ― 440*420*70 (110) mm.