Table for unsealing of honeycombs with a flat basket FB (1.5 m) (Sheet 0.5 AISI 304 stainless), stainless faucet

 The table for unpacking honeycombs is designed to create the greatest convenience for the worker when unpacking honeycomb frames.

Consists of a tank, basket, frame and a wooden beam with a needle. The tank and basket are made of stainless steel, the frame is made of a shaped tube. The tank is made with a slope towards the drain valve. The basket is installed in the tank near the end. In the upper part of the table, above the basket, a wooden crossbar with a needle is installed, on which the honeycomb frame is held when it is unsealed. The cut parts (casing) are collected in a basket. The honeycomb frames prepared for pumping out honey are suspended in the tank, starting from the opposite end of it. Honey flows from the cuts of honeycomb frames and the beading along the bottom towards the tap. The faucet is stainless. This model uses a flat basket.

In a new flat basket, the perforation (holes) are 5 mm.

Bath and basket material: AISI 304 stainless steel , 0.5 mm thick