RuBond ES150 S (50ml) One-component epoxy adhesive, thermosetting

RuBond ES 1 50 S is a one component metal filled epoxy composition - adhesive that does not spread when heated .        

K A Song has improved strength characteristics ,  with a maximum resistance to shock loads  and is intended for forming a durable adhesive connection , allows to replace such traditional systems bonding parts like a bolt , Klep full - time , soldered , welded , clamp ovoe  and t. D. This adhesive has excellent adhesion to various materials: metals, ceramics, ferrites, glass, composites , concrete, artificial stone, almost all plastic and,  and   etc. , and is used for gluing them in various combinations . Glue is optimal for use where imposed higher requirements for adhesive strength characteristics evogo compounds , conjugated with resistance to beats and frames ,  with simultaneous resistance spreadable under heating during polymerization .  

The adhesive is also suitable for joints with large gaps between mating parts (up to 3 mm).  

To Leu is about dnokomponentn th  Epoxy second  composition it , pre elapsed s  process of degassing  and ready nd  to the use of

Polymerization under standard conditions  

Surface preparation 

The surfaces must be cleaned, dried and degreased before applying the adhesive with  any  cleaner suitable for the parts to be bonded . M Ferrous materials, having a surface oxide film, must also be machined to remove it (recommended shortly before applying the adhesive).    

Bonding surfaces of the adhesive applied through the dispensing ustroyst in a suitable diameter. The composition  must be applied to the entire area of the junction of the parts, since the glue does not spread during polymerization . It is enough to apply the glue to one of the surfaces, while it is necessary to avoid the formation of air bubbles in it. When the mating of the parts they need to be sufficiently strong compression to the adhesive is evenly distributed over all  glue th  surfaces wells .  
  
 
 

The parts to be joined must be compressed with each other during the entire polymerization time of the composition.  

The displacement of parts relative to each other from the moment the glue begins to reject and until the moment they are glued can lead to a deterioration in the strength characteristics of the finished unit.  

In order to avoid displacement of parts during the polymerization of the glue, it is recommended to use mechanical means of  fastening the parts, such as clamps, clamps, etc. It is recommended to ensure the immobility of the connection unit until the glue has completely hardened.  
 

Storage 
 

When storing the composition outside the temperature range from + 5 to + 23 ° C , the manufacturer does not guarantee that the composition will retain its properties.