Plasters front TEPLOSTEN TShS-500P

Dry construction mix is intended for external and internal walls with normal moisture conditions (not of crude) rooms. Mix is prepared on the basis of vspuchenny by roasting of perlitovy sand bulk density 100-120¬ú/m3 therefore plaster very easy, has the high thermoresistance, high sound insulation and creates small loads of the bearing designs of buildings. Thermoresistance of 20 mm of a layer of pnrlitovy plaster in size same as walls ½ ceramic bricks thick therefore walls can be built more thinly, the bases less massive, is excluded need of warming of walls by polyfoam or mineral wool, gypsum cardboard. At the expense of it the cost of construction or repair decreases, and solidity increases.
Bag volume - 20/80 liters, weight - 8/32 kg. Way of drawing — manual Admissible thickness of a layer - from 10 to 50 mm
Technical characteristics: Waterproof Color - light gray Knitting - a portlandtsement Filler - vspucheny perlitovy sand The maximum fraction of filler - 1,25 mm The bulk density of dry mix - 380 kg ± 30 kg Heat conductivity — 0,08-0,1 W of canned meat Strength at compression — not less than 2,5 MPas Water consumption on 10 l of dry mix - 5 l ± 0,5l Temperature of use is not lower +5 0C Viability of solution — not less than 60 min.
Application: it is intended for warming of facades, preparation and alignment of walls from a brick and concrete in and outside of buildings.
Structure: vspuchenny perlitovy sand, high-quality portlandtsement and mineral additives.
Preparation of a surface before drawing: by preparation of the basis it is necessary to adhere to requirements Construction Norms and Regulations 3.04.01-87 and GSN B 2.6-22-2001. The basis has to be dry, cleared of dust, dirt, oils, wax and the remains of paint. Surfaces which strongly absorb moisture need to be processed a primer.

Solution preparation: to add dry mix to the container with water and to mix carefully on low turns before formation of homogeneous mass of necessary density without lumps. Temperature of solution has to be not lower + 10C.

Putting solution: solution is applied on a surface with a layer by not less than 5 mm and no more than 50 mm, then the surface is leveled and grind. on the dried-up surface it is possible to paste wall-paper, and also to paint and revet with a tile.