Nippelny drinking bowl (360) for young growth, quails, broiler chickens, ducklings and even Indo-ducks
- Customer pickup,
- In detail
- Country of manufactureBelgium
It is used for young growth, quails, broiler chickens, ducklings and even Indo-ducks. Capacity of the nipple is 70-90 ml/min. Fastens on a square pipe from PVC 22 x 22 on K1/8 carving (it is similar with 10х1). The case from special plastic, and internal part from high-quality stainless steel. Provides water supply by any lateral pressing a pusher (the 360th hail.) The producer of CLR (Turkey), or Glind (Belgium) both producers have worthy quality and it is impossible to tell who better, time showed. It is used also in a combination with a kapleulavlivatel, a microcup or a spring saucer. For installation in a pipe it is possible to drill an opening with a diameter of 9,0-9,2 mm. Looking at a pipe profile, the opening has to be there where two narrow strips between which a thickening and from above one strip as the amplifier for constant blows of the top head of the nipple. It is desirable to have the device for axial centering and perpendicularity. Then without silicones, fum tapes, etc., it is desirable by means of a treshchetka or the screw gun adjusted on the corresponding effort and heads on 10 to twist slowly. To PAY ATTENTION as one and other producer, has batches of nipples at which the case to be exact a carving, is couple millimeters longer than usual. Such the nipple needs be not to screwed up 2-3 rounds, otherwise the top head of a drinking bowl will rest against a pipe ceiling, in a closed position of the nipple. Nipple case material rather rigid, a carving conic therefore itself can cut under itself a carving. A tap to pass there is no need. It is very desirable to perform works in well heated the room (the cold pipe, when drilling or screwing, can give a microcrack). In cases when an opening in a pipe proslablo, or you bought a sovetsky second-hand pipe (it is a good pipe) with openings on 12, we recommend to use our cap / adapter from M10 on d - 12 mm which has a strong tightness and soft plastic which does not burst, as a result turn out VERY strong and tight connection. A good exit, at repair not to change a pipe and just to rassverlit openings on 12.