Milling

Milling Blastrac cars are well-known the powerful productivity and fitness for work under trying conditions.

Milling Blastrac cars are an irreplaceable equipment where it is necessary to remove an elastic or flexible floor covering, especially in cases when it is required a mechanical way to receive a rough surface. The principle of its work is rather simple: efficiency is reached by means of use of the rotating drum with lateral shaft which special nozzles in the form of various mills are put on.
Mills are divided by laying; having chosen a necessary interval between mills, it is possible to reach the desirable cutting ability; the rotating drum creates centrifugal force which pushes a mill into the processed surface, thereby promoting mechanical milling of a surface.

Blastrac offers a wide choice of mills: from steel mills with tungsten tips to firm tungsten mills which application is most effective on thicker flexible coverings.
For a complete description of the available mills address the section "Accessories of the Milling Equipment" or contact representative office of Blastrac in your country. Thanks to the wide range of milling cars and mills, the equipment can be used in various purposes:

• Engraving, cleaning, removal of paint from almost any surfaces.
• Removal of glue, pitch and more difficult coverings.
• Is ideally suited for removal of an old marking of highways.
• Alignment of uneven surfaces.
• Deep and exact mechanical crushing of concrete, pitch, asphalt, etc.

For satisfaction of any your requirements the Blastrac company offers a wide choice of models of cars:

• Small-sized models.
• The milling equipment with manual and hydraulic control.
• Cars with a petrol and electric motor.