- Country of manufactureBelarus
- Volume- L
- ColorLight blue
- KindColoring paint
Type: aqueous concentrated dispersion paint color «FRESKO» is a suspension of pigments and extender in the aqueous dispersion of acrylic copolymers with the introduction of special additives.
Scope: color paint is designed for self - tinting paint water dispersion for interior or exterior use (production of JSC "Lakokraska") in order to give them a bright or light pastel colors, while maintaining all the characteristics of paints. For intense color paint color may be used for internal works as an independent paint (for protective and decorative painting of walls in dry areas of concrete, brick, plaster, stopper and plasterboard surfaces, including painting, decoration and decoration).
Map pitch ratios color inks and base:
- tone number 1 red;
- orange tone № 2;
- Golden tone 3 №;
- tone number 4 bright yellow
- tone number 5 lemons;
- tone number 6 herb;
- tone № Green 7;
- tone number 8 sea wave;
- tone blue number 9;
- tone blue number 10;
- tone number 11 purple;
- tone number 12 Guard;
- tone number 13 brick;
- tone number 14 chocolate;
- tone number 15 coffee;
- tone number 16 black
|Must comply with the established reference color samples.|
|2||Appearance of coating||After drying, the coating must be opaque, smooth, homogeneous.|
|3||Viscosity at (20,0 ± 0,5) ° C by viscometer VZ - 246 with a nozzle diameter of 6 mm, with,
|60 (a data set)|
|4||Milling degree, um, not more than||10|
|5||Mass fraction of solids, % not less||64|
|6||Drying time to degree 3 at
(20 ± 2) ° C, h, max
|7||Hydrogen ion concentration, pH||8.5 - 9.5|
Properties: The color palette includes 16 tones of color inks. When you select a tone color inks to be considered the place of repair work - indoors or outdoors. For tinting facade paints using color - tone paint № 4, 6, 7, 8, 9, 10, 11, 12, 13, 14, 15, 16. For tinting waterborne paints for interior use all 16 tones color inks .
To select a desired tone color palette table is used (ratio of color inks with a water - dispersion paints production "Lakokraska" indicating mixing proportions). However, color - color data paints, as well as all - color tone ink may be mixed together in any proportion.
Benefits of color inks:
ease of use;
to conduct tinting waterborne paints at home (on - site repair);
obtaining a wide range of colors of varying intensity, including the color of the color palette table;
possible to adjust the shade of paint in the mixing process;
the possibility of using as an independent coating for interior use;
It does not contain solvents;
- The use of color inks for self - tinting water - dispersion paints for interior or exterior use.
Preparation of the surface before application of waterborne paints, otkolerovannyh using color inks - in accordance with the technical regulations for paint.
Before applying the color - paint must be thoroughly mixed.
For tinting takes color paint of the necessary tone, is added in small portions in white paint and carefully mixed. For uniform mixing, you can use an electric drill with different types of nozzles. To select a desired tone color palette is used indicating mixing proportions. By varying the ratio of color inks and white ink can independently achieve the desired color intensity and hue of color of the final product.
It must be remembered that the tinting at home received a shade difficult to reproduce. Therefore, the entire volume must be tinted directly and in a single container, calculating the volume of ink with a margin (20% ).
Application and drying waterborne paints, otkolerovannyh using color inks - in accordance with the technical regulations on the paint.
- The use of color inks as an independent paint intended for interior use.
The surface must be clean, dry, solid, exhibit good load bearing capacity and does not contain substances which reduce adhesion (release agents).
For priming and leveling absorbency, reducing flow of paint color, and increase adhesion strength to the substrate surface prepared by applying the primer recommended FRESKO «Imprelid» or primer deep penetration FRESKO «Imprelid Ultra» (to strengthen unconsolidated porous, fragile and grinding surfaces). Application and drying the primer carried out in accordance with recommendations for primer data TU BY 500021625.112. Land surface, the affected mold or fungus should be cleaned with steel brushes and then apply a primer FRESKO «Antisept Ultra» (TU BY 500021625.208), to prevent re - occurrence of the microorganisms.
For priming and leveling absorbency as a primer layer can be used as color - paint diluted with water in a ratio of 3: 1. The primer drying times of at least 2 hours at a temperature (20 ± 2) ° C and a relative humidity of 65% .
On the prepared base - color paint is applied by brush, roller or airless spray viscosity with the initial at least two layers, not including the primer. If necessary, the paint color is diluted with water of not more than 5% by weight of the color inks. Drying each layer - at least 2 hours at a temperature (20 ± 2) ° C and a relative humidity of not more than 65% . Paint drying time depends on the temperature, humidity and other factors.
Consumption by layer coating waterborne paints , otkolerovannyh using color inks - according to the main material flow rates.
Consumption by layer coating color inks when used as an independent ink is 100 - 120 g / m2, depending on the roughness, the porosity, absorbency of the substrate, the application method, the color - color paint, qualification painter. More precisely flow is determined by applying a test coating. When painting textured surfaces consumption is increased by 1.5 - 2 times.
It is not allowed to mix color inks with solvents of any kind. Diluted with water only.
After using the color inks on packaging intended purpose of the product residues to be tightly closed closures and sent to the consumer landfill.
Precautions: color paint is non - toxic, fire and explosion. When injected into the eyes, mucous membranes and the skin rinsed with water. Persons related to the paint work must be provided with personal protective equipment (overalls, safety glasses, rubber gloves).
The dried coating has no toxic effects on the human body.
Storage: color - ink kept in closed warehouses at ambient temperature from + 5 ° C to plus 35 ° C in tightly closed containers, protected from exposure to heat and direct sunlight. In winter, the color - ink is transported in insulated truck.