Installation for pressure testing gbts UG1400
- Customer pickup,
- Courier
- In detail
- BrandМоторные технологии
- Country of manufactureRussia
Installation for pressure testing of UG1400
Stands for hydraulic tests of production "Motor Technologies" allow to diagnose problem zones of internal combustion engines of all modern cars. The principle of operation of the equipment consists in check of knots on tightness with use of compressed air in the water environment.
Complete set:
- The stand for hydraulic tests
- Passport and maintenance instruction
- Plexiglas (a set from 4 pieces)
- Emphasis for details (2 pieces)
- Clips (5 pieces) and hairpins for tightening (5 m)
- Vacuum rubber
- Device for fastening of inclined GBTs
- Nuts, rings, washers
The stand for pressure testing of GBTs – the tool for check of products on microcracks. Tightness – one of the major characteristics causing correct operation of the engine of the car. Stands for pressure testing are used to testing of internal cavities of GBTs for existence and location of cracks. For this purpose the detail is pressurized and located in a bathtub with hot water. Then through one of openings compressed air moves. If on a water surface there were vials of air proceeding from the tested detail, then it demonstrates existence of cracks.