- Weight4500 kg
The car one-position for molding under pressure of DE3132 - 250Ts1 it is intended for production of products from molding brands of thermoreactive materials with a temperature of plastication up to 432 To (150 °C).
The mode of molding pressing for receiving products of the increased accuracy and a difficult configuration is provided in the car.
FEATURES OF THE DESIGN
The double horizontal lever mechanism of locking of an original design provides a reliable smykaniye of a compression mold and differs in the small mobile masses, high rapidity. Locking with a low pressure protects a compression mold from breakages. The central mechanical pusher smoothly pushes together a finished product at the expense of different speeds of mobile and intermediate plates.
differs in high compactness. The screw drive - the high-moment hydromotor. The knot moves in the axial direction on columns by means of two cylinders of a clip.
Hydroblocks are executed on the valvate hydroequipment which is built in openings and located in close proximity to executive mechanisms. The hydraulic actuator provides smooth regulation of technological parameters.
Electronic control system
it is established by car and operates a cycle of a reaktoplastavtomat and temperature with a conclusion of all information to the display.
Diameter of the screw - 50 mm
Molding pressure - 150 MPas
Working volume - 300 cubic cm
Effort of locking - 1750 kN
Plate course length - 400 mm
Height of the installed tool - 200-400 mm
The pusher course - 135 mm
Distance between columns in light, horizontal - 500 mm
Distance between columns in light, vertical - 400 mm
Electric motor power - 22 kW
The mass of the car - 5200 kg
length - 4500 mm
width - 1250 mm
height - 1950 mm