Countertop marble surface Wild stone, article 1826

Tabletop marble surface Wild stone, article 1826 Working plates: working plates are made on the basis of chipboard, covered with laminated plastic from leading European companies, which is produced using high pressure technologies.  

Plates can be used as:

• kitchen worktops;
• desk tops;
• shop counters;
• internal window sills;
• bar counters;
• interior decoration of banks, offices, shops, hotels, restaurants;

The surface of laminated boards is characterized by increased resistance to: temperature, abrasion, sunlight, burning cigarettes, impacts, chemicals.

Cutting products: sawing of plates must be carried out with the help of a disk plate with a decorative surface upwards. The saw must be driven slowly along the ruler or guide in the direction of the revolutions of the disk, which cuts into the decorative surface of the plates. If the disc turns in the opposite direction, the plate must be installed with the decorative surface down.

Guidelines for the consumer: for finishing the side ends, it is necessary to use edge plastic with an adhesive for pressing in at a temperature of 150 ° C. Removing the edge plastic from the weight must be done in such a way that after processing there is no open chipboard at the corners. Water does not cause any harm to the surface of the countertop, but it can adversely affect the material of the plate - the base. Even when using imported moisture - resistant chipboard, which is usually installed in rooms with high humidity, the ingress of moisture into open or poorly enclosed areas of chipboard leads to swelling of the products. To avoid this, it is necessary to carefully arrange a moisture barrier in all open areas of chipboard, especially in the place where the sink is mounted. It is important to always immediately wipe up water splashed on the countertop,

Not recommended: use countertops in showers, bathrooms, as well as in rooms with high humidity. The air temperature should not exceed 80°C.

Care: Contaminated surface can be easily cleaned with water and liquid detergents, abrasive products should be avoided.

When unloading or loading manually, the following rules must be observed:

1. When loading into a container or car, first put a chipboard sheet, then lay the products on it. The products are placed against the wall of the container or the side of the car with the side where there is no postforming,

2. When loading (unloading) do not allow the product to slide against each other.

3. Shoot 1 pc. , supporting from both ends, countertops based on moisture - resistant chipboard.

Today, Russian buyers of kitchen furniture place high demands on the appearance and quality of the products they offer. Getting acquainted with samples of imported furniture, Russians want to see beautiful and modern furniture sets in their homes. To date, European manufacturers for the manufacture of kitchens use 40 mm thick countertops based on green chipboard with increased moisture resistance. Furniture company SBK has launched serial production of countertops with a thickness of 40mm, 28mm based on chipboard with increased moisture resistance. More recently, the distance between the upper cabinets and the work surface of the table in the kitchen was tiled. Tiling is labor intensive. Requires professional skills and high cash costs. Today, all European kitchen factories recommend that their customers, in order to improve the design, cover this distance with a furniture board or the so - called kitchen panel. The furniture board perfectly matches the color of the countertop, the joint between them is closed with a sealing plinth, decorates the product and increases its performance. An additional advantage - the furniture board helps to hide the unevenness of the walls.