BOYET Series
Product Name/Model：BYTF605-Epoxy Primer
Characteristic: Good fillibility, easy sanding, give excellent rust proofing for bare metal, good
adhesion power to steel, aluminium, galvanized steel and stainless steel, excellent chemical
corrosion resistance and rust resistance.
|
Substrates |
Dried and sanded existing finishes, steel, aluminium, stainless steel, galvanized steel, |
||
|
Surface Cleaning |
Wash by warm soap, remove wax, silicon and other contaminations with degreaser, |
||
|
Mixing Ratio |
BYTF605 Epoxy Primer |
BYTH105 Epoxy Hardener |
BYTX-5 Epoxy Thinner |
|
4 |
1 |
1~2 |
|
|
＜30℃ |
BYTF605 Epoxy Primer |
BYTH105 Epoxy Hardener |
BYTX-5 Epoxy Thinner |
|
Spray Viscosity |
16-19s to drop off, in 4# viscosity cup at 25°C, |
||
|
Pot-life |
At 20°C, 3 hours with hardener. |
||
|
Re-Treatment |
Sanded with P600 or P800 sand paper, do following construction after drying |
||
|
Spray Gun Set Up |
Gravity Feed: 1.2-1.5mm 4-5kg/cm 2 |
||
|
Spray Technology |
Coats&Thickness: 2-3 coats, total 25-35um. |
||
|
Drying Time |
A. Allow 10-20 minutes air-drying,then 60°C baking 30 minutes, can sand after cool |
||
|
Shelf Life |
2 years in original sealed can, cool and dry place at 25℃. |
||
|
Package |
1L×12 or 3.75L×4 |
Note:
1. The substrate must be cleaned and sanded before spray, wet sanding P800-1000 and then dry.
2. At ambient temperature higher than 30℃, add appropriate Retarder Solvent into thinner to
avoid blushing. For more details, please refer to technical data sheet of Retarder Solvent.
3. The products mixed with hardener should be used up soon and can not be restore for future use;
clean equipments immediately with thinner after application, otherwise it is very difficult to be cleaned after dry.