Brake pads (friction linings, ferrodo, blocks) on the fan to the Bulgarian telphers with a loading capacity of 1 t; 2 t; 3,2t; 5

The brake overlay (it is a slip frictional) for the Bulgarian elektrotelfer of a series T is a part of a brake of the electric motor which is established between the fan and a casing of the fan. It is quickly worn out part of a brake of the electric motor, it is made of frictional material and has the cone-shaped form. The brake moment is carried out due to braking of the disk fan about a pig-iron casing of the fan. There is it because the rotor has the axial course and when giving power supply it is involved and the engine rastormazhivatsya, and at shutdown of power supply the electric motor slows down automatically.

     In use an elektrotelfer it is necessary to watch a condition of a slip. When the brake (frictional) slip, because of wear, reaches thickness 1,5mm it is necessary to make its replacement. For this purpose it is necessary:

1.      To remove a casing and the fan lattice attached to it;

2.      To unscrew the regulating nut;

3.      To remove the fan and to replace a worn-out brake slip on new which to fasten on a fan disk by means of epoxy glue and rivets;

4.      To install the fan, and then to put the back regulating clamp;

5.      To establish a fan casing with the attached fan lattice.

     After replacement of a slip it is necessary to check work of a brake, to adjust it and only after that it is possible to operate a telfer in the corresponding operating mode.

     If you need to get a brake slip address us. We offer frictional overlays of all gruzopodjemnost from existence at the lowest prices.

Brake slip (a frictional slip, ferrodo) on the fan to the Bulgarian telfer with a loading capacity of 1 t - catalog No. 430044; 2 t and 3,2t - 430084; 5 t - 430066