Chains of antisliding are applied on friable and unstable surfaces, on forest and country roads, boggy places where there is an abundance of dirt and also on snow-covered and winter roads to ice time. For an obstacle of slipping of wheels.
We make antisliding chains on any sizes of wheels, since cars and finishing with chains of antisliding of special application, on special equipment. Depending on features of cars and road conditions the different chains of antisliding made of a chain with a diameter of 5 mm, 6 mm, 7 mm, 8 mm, 9 mm are used. To choose a chain of antisliding it is required to consider diameter of a wheel and the sizes of wheel arches of a car.
At a chain the executed "short flight of stairs" simple on a design put on easier, at them more the best grebuchest and traction characteristics than in other executions are higher, and it is easier on weight. Generally they are put on the conducted wheels.
Installation conditions:
If you had not to put on and remove chains yet, it is better for you to be trained.
You store chains in a luggage carrier. In the same place there have to be dense gloves and a dynamometer key.
Remember that it is impossible to establish antisliding chains on emergency wheels.
Before installation of chains take off caps.
It is recommended to dress chains just before overcoming of an impassable site of the road and right after its overcoming to remove. Following these rules, you keep a car suspension bracket, and tires from faster wear.
It is necessary to park the car on an equal site. To put couple of chains directly before wheels. Look that locks were from outer side, and links and knots were not overwound. If everything is all right, run into a chain approximately on 40 cm. It will allow you to throw easily with the main part a wheel, and then straighten, pull and clasp a chain. Further it is necessary to roll chains, having passed 10-30 meters in order that the chain settled and then again to tighten locks.
For our dealers and wholesalers discounts always work!